FeiYu Tech FY-3ZT - Manual (Page 23)

GuiLin FeiYu Electronic Technology Co., Ltd.
GuiLin FeiYu Electronic Technology Co., Ltd http://www.feiyudz.cn E-mail: [email protected]
Page 22
a) Option 3 is the combination of Option 1 and Option 2.
b) In Option 3, you will require two receivers of the same frequency.
c) Ensure that both receivers can be controlled by your RC transmitter.
d) One receiver is installed on board the aircraft (as per Option 2), while the other receiver is
installed at the Ground Station (as per Option 1).
e) The Channel utilization on both the on-board receiver and Ground Station receiver must be
the same.
f) The Ground Station Receiver must be at least 6 channels, while the On-Board Receiver must
be at least 7 channels.
g) Two of the channels require a three-position switch (e.g. Channel 5 and 6), while Channel 7
is used to select either Data Radio (RC receiver on ground) or by the RC Transmitter to
control the aircraft.
OPTION 3: GROUND STATION CONTROL DIAGRAMME
WARNING: If you wish to use a 5
volt Receiver battery to power the
ground
station system, please
disconnect the 5 volt power in-coming
from the USB Interface cable.