FeiYu Tech FY-3ZT - Manual (Page 44)

GuiLin FeiYu Electronic Technology Co., Ltd.
GuiLin FeiYu Electronic Technology Co., Ltd http://www.feiyudz.cn E-mail: [email protected]
Page 43
SERVO CONTROL DIRECTION AND DEBUGGING
ATTENTION! It is recommended that you remove your prop or disable your motor while
performing these setup procedures!
1. The FY-3ZT module has its own mixing function. Therefore the RC transmitter can be
programmed for a ―normal‖ layout aircraft.
2. Please choose the correct mixing mode in ―Mix control‖ to change the layout of the aircraft.
Following is a table describing the possible layouts:
Layout Options
Normal layout plane No mix (AIL NAV) or
No mix (AIL&RUD NAV)
Delta-winged plane with rudder ELE and AIL mix (AIL NAV) or
ELE and AIL mix (AIL&RUD NAV)
Delta-winged plane without rudder ELE and AIL mix (AIL NAV)
plane without aileron but with elevator and
rudder No mix (AIL NAV)
PRE-FLIGHT CHECK:
3. The following procedure explains how to correct servo control direction upon FY-3ZT
activation.
4. Control direction check: Please set the:

"Rud stability" = 20

"Pitch stability‖ = 50

"Roll stability" = 50
then switch to the "Auto Balance Mode" mode, check the
control direction as explained below.