The power-on self test (post), The power-on self test (post) -2, Bios utilities 5 - 2 the power-on self test (post) – Eurocom D700T Enigma User Manual

Page 82: Figure 5 - 1

BIOS Utilities

5 - 2 The Power-On Self Test (POST)

The Power-On Self Test (POST)

Each time you turn on the computer, the system takes a few seconds to con-
duct a POST, including a quick test of the on-board RAM (memory).

As the POST proceeds, the computer will tell you if there is anything wrong.
If there is a problem that prevents the system from booting, it will display a
system summary and prompt you to run Setup.

If there are no problems, the Setup prompt will disappear and the system will
load the operating system. Once that starts, you can’t get into Setup without
rebooting.

POST Screen

1.BIOS information
2.CPU type
3.Memory status
4.Enter Setup prompt

appears only during
POST

Note: The POST
screen as pictured is
for guideline purposes
only. The POST
screen on your com-
puter may appear
slightly different.

Figure 5 - 1

POST Screen

Phoenix cME FirstBIOS Notebook Pro

BIOS Revision: V146 1.00.P01

KBC/EC Firmware Revision: 1.00.D8

VBIOS Revision: 5.41.02.18.AC-09/24/04

CPU = Intel(R) Pentium(R) 4 CPU 3.20GHz

1023M System RAM Passed

1024K Cache SRAM Passed

System BIOS shadowed

Video BIOS shadowed

ATAPI CD-ROM: TSSTcorpCD/DVDW TS-L532A

Fixed Disk 0: FUJITSU MHT2060BH

USB: Y-E DATA USB-FDU

Mouse intialized

Press to enter SETUP

Boot Logo Screen

If you have enabled
the Boot Logo Screen
then the POST screen
will not appear.

You

can still press F2 to en-
ter Setup (see

“Boot

Logo Screen:” on
page 5 - 10