Echelon OpenLDV - Manual (Page 93)

OpenLDV Programmer’s Guide 85
Network Interface
Command Value Direction Description
niSERVICE 0xE6 Downlink Requests that the network interface
send a service pin message. This
command has the same effect as
activating the device’s service pin.
Some network interfaces might not
support this command.
niXDRVESC 0xEF Uplink
Downlink This command applies to xDriver
network interfaces only.
This message must contain a data
payload in addition to the command
and length bytes. The first byte of
the data field denotes an xDriver-
specific command; see Table 34.
For information about other
immediate commands that are
specific to a particular network
interface, see the documentation for
that network interface. For
example, the Power Line SLTA
Adapter and Power Line PSG/3
User’s Guide contains descriptions
of commands specific to the
SLTA/PSG interface products that
can be used to control dial-up
connections through a modem.
Table 34 on page 86 describes the xDriver-specific commands that you can use
with the niXDRVESC immediate command. The niXDRVESC immediate
command is described in Table 33 above.