Echelon OpenLDV - Manual (Page 90)

82 Sending and Receiving Messages with the OpenLDV API
Network Interface
Command Value Direction Description
niL2_PRE_SHORT 0x34 Uplink Specifies a “Preamble Too Short”
error condition for a Layer 2
network interface.
niL2_PKT_SHORT 0x35 Uplink Specifies a “Packet Too Short” error
condition for a Layer 2 network
interface.
niL2_FREQ_RPT 0x40 Uplink Specifies an incoming frequency
report from a Layer 2 network
interface.
niRESET 0x50 Uplink
Downlink Uplink: Specifies that the network
interface has executed a hardware
or software reset.
Downlink: Requests a reset of the
network interface.
Applies to both Layer 2 and Layer 5
network interfaces.
niFLUSH_CANCEL 0x60 Downlink Requests that the network interface
cancel any flush operation posted
with the niFLUSH command or
caused by device reset.
The OpenLDV application must
issue this command after a
successful completion of the
ldv_open() function.
You can use the NiInit() function,
which is part of the OpenLDV
Developer Example to open a
connection to a network interface
more conveniently.
niFLUSH_COMPLETE 0x60 Uplink Specifies that a flush operation
posted with the niFLUSH
command has completed.