D-Link DCS-5220 - Manual (Page 82)

D-Link DCS-50 User Manual
Section - Configuration
There are three controlling units in both “Begin Time” and “End Time” selectors shown below. The first unit of these two
selectors is the date picker. You can select day with it to set the beginning time and the ending time for the recording
interval.
The second and third units are the hour picker and the minute picker. You can change the hour and minute settings
for the beginning and ending time with them.
Note: The time set in “Begin time” must be earlier than that in “End time”. Otherwise the settings will not be applied.
Marking/Unmarking the Recording Time on the Hour Time-Line
You can apply the one-click function by clicking the left mouse button and dragging to mark the time on this time-line.
The operating method for the hour time-line is the same as that of the week time-lines. Please refer to the previous
section about marking/unmarking on the week time-line for more details.
Schedule with Time Picker
Begin and End Time
Apply and Erase Buttons
After you have selected the time period with “Begin time” and “End time” picker, you can apply the period picker, shown
in the figure below, to set the periodical types of the time interval set previously. After the settings in “Begin Time”, “End
Time” and “Period Picker” are all done, you should click the “Apply” button or “Erase” button on the right to add or clear
this scheduling information to the editing schedule scheme. Note that only after you click on the “Apply” button, the
scheduling information settings will be written back into the whole editing schedule scheme. That means this edited
scheduling time interval is valid only after you “Apply” the changes.