D-Link DCS-5220 - Manual (Page 26)

D-Link DCS-50 User Manual
Section - Configuration
This option can turn off the wireless function. The
camera server will detect the connection type when
booting, it will detect a wired connection first, and
then wireless. If wireless is not connected during
booting, it will not detect again. If wireless is disabled,
the camera will not detect wireless during booting.
(Service Set Identifier) is a name that identifies a
wireless network. Access Points and wireless clients
attempting to connect to a specific WLAN (Wireless
Local Area Network) must use the same SSID. The
default setting is dlink.
Click on the drop-down list and select from the
following options:
Infrastructure - connecting the WLAN using an
Access Point such as the DWL-100AP or a DI- wireless router.
Ad-Hoc – wireless mode used when connecting directly to a computer equipped with a wireless adapter in a peer-to-peer
environment.
In Infrastructure mode, the wireless channel is automatically selected by the camera. In Ad-Hoc mode, the default wireless
channel setting is channel . Select the channel that is the same as the other wireless devices on your network.
Select the transmission rate on the network. Auto is the default setting.
Preamble Type - Short or Long. If your wireless network support Short Preamble, then enabling it can boost overall
throughput. However, if any wireless device does not support Short Preamble, then it will not be able to communicate with
your network. If you are not sure whether your radio supports the Short RF preamble, then make sure you disable this
feature. Long Preamble is the default, as it is a required setting for Wi-Fi compatibility.
Select the encryption type from the drop-down list. The default setting for encryption is None, which means the security is
disabled.
Wireless Setup
Disable Wireless:
SSID:
Wireless Mode:
Channel:
TX Rate:
Preamble:
Security: