D-Link DCS-5220 - Manual (Page 105)

105 D-Link DCS-50 User Manual
Section - Configuration
Display Adjustment Tool
When you move the mouse cursor to the displaying area, the display adjustment toolbox will appear. Using the display
adjustment toolbox, you can change the displaying video sequence to the size you want to see in the normal display
mode when you move the area selection indicator to the display area. The figure below shows the display adjustment
toolbox and its own three elements, i.e. “Zoom In”, “Zoom Out”, and “Full Screen.”
When you click on the “Zoom In” button one time, the image size
in the display area will be magnified 12.5 percent to the original
size. Due to the limitation of the display area size, the maximum
zoom in ratio supported is only 2.25:1 for NTSC modulation mode
and 1.875:1 for PAL modulation mode. If you want to see the
image in more detail, you can use the full screen function that
is supported in the same toolbox.
When you click on the “Zoom Out” button one time, the image
size in the display area will be minified 12.5 percent to the original size. To show the location and time
information completely, the minimum zoom out ratio is limited in 0.5:1.
When you click on the “Full Screen” button, the video sequence will be enlarged to the whole screen
instantly. You can double click on any place or the “ESC” key to return back to the normal screen. When
you switch to the full screen display, you can press the “Alt” and “Space” keys together to pop the jog dial
to control the displaying video sequence. Press the same keys again to close the jog dial. You can also
press the “Alt” and “Enter” keys together to switch between the normal display and full screen display
at any time when the program is under the normal display mode.
Zoom In:
Zoom Out:
Full Screen: