Akai MPC 1000 - Manual (Page 56)

MPC1000 v2 Operator’s Manual rev 1.0
46 Chapter 8: Q-Link slider
Other features of Q-Link slider
Feature in TRIM mode
In the TRIM page and LOOP page within TRIM mode,
holding in the [AFTER] key while manipulating the Q-
Link sliders.
[AFTER] key + Q1 slider
TRIM page : This can adjust the start point.
LOOP page : This can adjust the loop start point.
[AFTER] key + Q2 slider
TRIM page : This can adjust the end point.
LOOP page : This can adjust the loop end point.
Q-Link slider also have the following features.
Feature in MIXER mode
In the L/PAN page in the MIXER mode, the Q-Link
slider work as follows :
Q1 slider : This can control the level of the selected pad.
Q2 slider : This can control the pan of the selected pad.