Canon C3200 User Manual
Page 524
Error Messages
12-9
T
roub
leshooting
12
No response from the server. Check the settings.
Cause
The specified server settings are incorrect, or the server is not turned ON.
Alternatively, the machine's TCP/IP resources may be low.
Remedy
Wait for a while, and try browsing again. If you still fail, try selecting another
server.
NetWare is in use. Wait for a moment, then perform operation again.
Cause
You cannot browse the network because NetWare is printing through a PServer
or NDS PServer.
Remedy
Wait until printing is complete, and try browsing again.
There are too many sub directories.
Cause
You have exceeded the maximum number of subdirectory levels allowed.
Remedy
The directory level that you are trying to access cannot be specified. Specify a
different destination.
No response.
Cause 1
The server was not running when you tried to send.
Remedy
Check the destination.
Cause 2
The network connection was lost when you tried to send. (Either you could not
connect to the destination or the connection was lost before the job could
complete.)
Remedy
Check the status of the network.
Cause 3
You tried to send through NetWare, but the Tree name was not entered.
Remedy
Enter the Tree name.
Cause 4
A TCP/IP error occurred when you tried to send an e-mail or I-fax.
Remedy
Check that the network cables and connectors are properly connected.
Check the TCP/IP.
Cause
The machine's TCP/IP is not operating.
Remedy
Check the IP Address Settings (IP Address, DHCP, RARP, BOOTP) in TCP/IP
Settings in Network Settings in System Settings (from the Additional Functions
screen). (See Chapter 3, "Using a TCP/IP Network," in the Network Guide.)