Canon C3200 - Manual (Page 523)

Error Messages 12-8
T
roub
leshooting
12
Error Messages
This section explains the various messages that appear on the touch panel display,
along with possible causes and remedies.
For explanations of messages that are not listed here, see the Reference Guide,
Facsimile Guide, and Network Guide.
Self-Diagnostic Display
Perform the necessary procedures according to the displayed self-diagnostic error
message.
Self-diagnostic error messages appear on the touch panel display at the following
times:
• When scanning or printing cannot be performed because of an operational error
• When you need to make a decision or take some action during scanning or
printing
• When you need to make a decision or take some action while browsing the
network
The following is a list of self-diagnostic error messages, along with their possible
causes and remedies.
Out of resources. Wait for a moment, then perform operation again.
Cause You cannot browse the network due to a lack of TCP/IP resources. This may be
because documents have just been continuously sent or are being continuously
sent through FTP or Windows (SMB).
Remedy Wait for a while, and try browsing again.
Set the IP Address.
Cause This machine is not set with an IP address.
Remedy Specify the IP Address Settings in TCP/IP Settings in Network Settings in
System Settings (from the Additional Functions screen), then turn the
machine's main power OFF and back ON again.