YSI 6000UPG - Manual (Page 32)

2-22
2. That parameter must be activated in the Report section of the Main Menu.
Select 4-Report from the Main sonde menu. The Report Setup menu will be displayed.
The asterisk (*) following a given number or letter indicates that the parameter will appear on all
outputs and reports. To turn a parameter on or off, type the number or letter of that parameter at
the cursor. Continue this process until all parameters are either on or off as you wish.
After configuring your display with the desired parameters, press 0 or Esc to return to the Main
Menu.
See Section 4 for a more detailed description of the sonde menus. The sonde software is now set
up and ready to calibrate and run. Proceed to Section 3.
========================================
Report-setup
----------------------------------------
1-(*) Date
G-(*) Sal ppt
2-(*) Time H-(*) DO %
3-(*) Temp C I-(*) DO mg/L
4-( ) Temp F J-( ) Depth ft
5-( ) Temp K K-( ) Depth m
6-(*) SpCond mS/cm L-(*) pH
7-( ) SpCond uS/cm M-( ) pH mV
8-( ) Cond mS/cm N-( ) ORP mV
9-( ) Cond uS/cm O-( ) NH4+ mg-N/L
A-( ) Resist MOhm*cm P-( ) NH3 mg-N/L
B-( ) Resist KOhm*cm Q-( ) NO3- mg-N/L
C-( ) Resist Ohm*cm R-( ) Turb NTU
D-( ) TDS g/L S-( ) TDG mm-Hg
E-( ) TDS kg/L T-(*) Batt V
F-( ) TDS mg/L
Select option (0 for previous menu):