Toa M-864D - Manual (Page 60)

FCC REQUIREMENTS
Note
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Modifications
Any modifications made to this device that are not approved by TOA Corporation may void the authority
granted to the user by the FCC to operate this equipment.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
URL: http://www.toa.jp/
133-02-00019-02
Traceability Information for Europe
Manufacturer:
TOA Corporation
7-2-1, Minatojima-Nakamachi, Chuo-ku, Kobe, Hyogo,
Japan
Authorized representative:
TOA Electronics Europe GmbH
Suederstrasse 282, 20537 Hamburg,
Germany
28.5. ZM-9014
Power Source 24 V DC (supplied from M-864D)
Current Consumption 50 mA or less
Terminal Removable terminal block (10 pins)
Connection Cable Shielded CPEV cable (paired data line and paired power line) or
Category 5 twisted pair cable for LAN (CAT5-STP)
Operating Section 4 function buttons
1 volume control knob
Indicator 4 operation indicators (green LEDs)
Volume set position indicator (7-point green LED)
Operating Temperature 0 to 40°C (32 to 104°F)
Operating Humidity 35 to 80%RH (no condensation)
Finish Surface-treated steel panel, white, paint
Dimensions 120 (w) x 127 (h) x 58.5 (d) mm (4.72” x 5” x 2.3”)
Weight 374 g (0.82 lb)
Note: The design and specifications are subject to change without notice for improvement.
• Accessories
Box mounting screw (No. 6-32UNC x 30) ...... 4
Box mounting screw (M4 x 30) ....................... 4
Panel mounting screw .................................... 4
Removable terminal plug (10 pins) ................. 1
Note: Since no electrical box is supplied with the unit, prepare it separately.