Toa M-864D - Manual (Page 16)

16
The figure below shows a signal flow.
Assignment switch
Input
STEREO INPUT 1
L
R
L
R
STEREO INPUT 2
OUTPUT 1
(Outputs the mixed L signal of STEREO INPUTs 1 and 2)
OUTPUT 2
(Outputs the mixed R signal of STEREO INPUTs 1 and 2)
REC OUT R*
(Outputs the mixed R signal of STEREO INPUTs 1 and 2))
REC OUT L*
(Outputs the mixed L signal of STEREO INPUTs 1 and 2)
OUTPUT 3
(Outputs the mixed L+R signals of STEREO INPUT 2)
OUTPUT 4
(Outputs the mixed L+R signals of STEREO INPUT 1)
1 2 3 4
Set the REC OUT assignment using the supplied M-864D PC Software.
The REC OUT default assignment is as follows.
REC OUT L: Assignment switch 1
REC OUT R: Assignment switch 2
*
10. PHANTOM POWER, PAD, AND GAIN SETTINGS
The input sensitivity and phantom power ON or OFF can be set to Monaural inputs 1 through 8 depending on
the devices to be connected.
Perform these settings by the control knobs after placing the M-864D in Gain control mode.
10.1. Setting Procedures
Step 1. Place the M-864D in Gain control mode.
Step 2. Perform settings as follows depending on the device to be connected. (See the next page.)
Device to be connected
Settings
Phantom power PAD
Dynamic microphone OFF OFF
Condenser microphone
(When phantom power is required)
ON OFF
Line input device OFF ON
Step 3. Adjust the gain. (See the next page.)