Toa M-864D - Manual (Page 24)

24
15. VOLUME LEVEL ADJUSTMENT
15.1. Adjusting Input and Output Volume Levels
Each volume level of inputs and outputs can be adjusted in the following 4 methods.
(a) Adjustment by the front panel mounted faders
(b) Adjustment using the supplied M-864D PC Software
(c) Adjustment by the optional ZM Remote controller
(d) Adjustment by the external control device
The configuration of these volume controls is as shown below.
ON
(a) (b) (c) (d)
OFF
ON
OFF
ON
OFF
15.1.1. Adjustment by the front panel mounted Faders
INPUTs 1 – 8 faders
M-864D
ST 1 and ST 2 faders OUTPUTs 1 – 4 faders
• INPUTs 1 – 8 faders
Adjust each input level of the MONO INPUTs 1 through 8.
• ST1 and ST2 faders
Adjust the input levels of the STEREO INPUT 1 (A, B, and C inputs of Stereo input terminals) and STEREO
INPUT 2 (A, B, and C inputs of Stereo input terminals, and front mounted Stereo input 2).
Each input is mixed and output. Adjust the mixing volume with the Trim control.
Note
Front mounted Stereo input 2 of the STEREO INPUT 2 is always output.
For details, read the separate Software instructions.
• OUTPUTs 1 – 4 faders
Adjust each output level of the OUTPUTs 1 through 4.