Toa M-864D - Manual (Page 48)

48
Lit while the button
is held down
Function button
Operation indicator
Lit
Function button
Operation indicator
Unlit
25.2. Operation
Operations of the Function buttons and the Volume control knob on the ZM Remote controller differ depending
on the functions assigned using the M-864D PC Software.
25.2.1. Function button operation
[When the Volume control function is assigned to the Function button]
It is possible to increase or decrease the Crosspoint gain and the external volume levels of the Monaural inputs
1 through 8, Stereo inputs 1 and 2, Monaural output 1 through 4, and Recording output.
Press the Function button several times while hearing the
sound volume.
The volume level changes by 1 dB each time the button
is pressed.
[When a function other than the Volume control is assigned to the Function button]
Following are assignable functions:
• Channel On/Off
• ST Line Source Select
• Matrix Crosspoint Assign
• Matrix Crosspoint Gain
• Preset Memory Load
• Remote Switched Out
• Remote Command
• EXT VOL. GainCS (Channel Select)
• Matrix Crosspoint GainCS (Crosspoint Select)
Step 1. Press the Function button.
The function assigned to the button is enabled.
Step 2. Press the Function button again.
The function assigned to the button is disabled.
Tip
When the status of the function assigned to the Function button changes by other device’s operation, the
Operation indicator corresponding to the Function button reflects its change.
For example, when the recall function of Preset memory No. 1 has been assigned to the Function button, if the
Present memory No. 2 is recalled through the M-864D’s front key operation, the indicator at the Function button
goes off.
ZM-9014 only