TeeJet Swath XL SmartPad II - Manual (Page 171)

SmartPad II
Software Version 4.03
Chapter 4 - Waypoint Navigation 4-35
Nav 2 Point Real-Time Scenarios
Figure 4 -44, shows the operator selecting the Start Navigation button (left side). Once the Start Navigation button is
selected, the Navigate to dialog will appear, Figure 4 -44 (right side) This dialog will list any points or sample points
that exist in the Grid/Points file. Once a point is selected, the operator will be guided to the point via a line that con-
nects the vehicle to the selected point, Figure 4 -45. Note the Start Navigation button changes to the Stop Navigation
button. The operator will select the Stop Navigation button when they are finished navigating to the selected point,
Figure 4 -45 (right side). If the operator has elected to use the lightbar as a navigation aid, Setup -> Lightbar, then the
lightbar will also display distance to point, point name and guide the operator to the point using the Cross-track
LEDs. This feature has been implemented into the Fieldware Nav2Pt product and should be used as an example of
how it will be implemented in this product.
Figure 4 -46 shows the buttons that would be used in the button bar for the example described in this example. The
map boundary buttons could also be used in this example if the operator had elected to map a boundary as well.
Figure 4-44: Selecting a Point to Navigate to.
Figure 4-45: Navigating to a Point