Dynamic host configuration protocol (dhcp), Ip addresses and routing, Domain name server (optional) – StarTech.com SV1641HDIE User Manual
Page 18
Instruction Manual
13
Dynamic Host Configuration Protocol (DHCP)
Automatic network configuration using DHCP is: Enabled/Disabled. This feature applies
only to the LAN port on the rear panel, and is enabled by default. When enabled,
the unit will automatically configure itself with an IP address when a DHCP server
is present. When disabled, the LAN port will use the values assigned to it on the IP
Addresses and Routing table below.
IP Addresses and Routing
This table allows you to assign IP information for the LAN port. If you are using DHCP,
the values for the LAN port will be filled in automatically and any changes made will
not affect the setup.
Domain Name Server (optional)
This section allows you to specify DNS servers and the default DNS domain suffix in use
on the network. If DHCP is enabled, some of these values may be supplied automatically.