beautypg.com

Terminal configuration using a serial cable – StarTech.com SV1641HDIE User Manual

Page 14

background image

Instruction Manual

9

Terminal Configuration Using a Serial Cable

Configuring the IP KVM switch using a serial cable is the best choice if you need to

preconfigure the unit before attaching it to a network, (i.e. when sending to a branch

office, customer site, etc). In general, the Web configuration is preferable because of

its intuitive interface and the fact that you do not have to be within close physical

proximity to perform the configuration. However, if you wish to use the serial cable

method to configure the IP KVM switch, you can use any typical communication

software package (UNIX: tip, cu, kermit, minicom; Windows: HyperTerminal, kermit).
You can use the serial port on the SVxx41HDIE to access the terminal configuration

tool; to do so, you will require a null modem serial cable. Connect a female end of a

serial cable to the serial port used for serial access on the host computer. Connect the

opposite end to the SVxx41HDIE. Configure the terminal software with “8N1” settings:

Connection speed: 115200 bps

No. of bits: 8

Parity: None

Stop bits: 1

*Sample HyperTerminal Configuration

This manual is related to the following products: