beautypg.com

Web configuration using static ip – StarTech.com SV1641HDIE User Manual

Page 13

background image

Instruction Manual

8

Web Configuration Using Static IP

Since some networks rely on static IP addresses (every device has a pre-configured

IP address that does not change), the DHCP access method described above is not

applicable in those situations.
To access the Web configuration for this product, you will need to configure the

workstation you are using to the same subnet (255.255.255.0) and also assign it a valid IP

address (i.e. 192.168.1.100). For details on how to change the IP address of your computer

(if necessary), consult your documentation or System Administrator for assistance.
NOTE: It is advisable to verify whether another device on your network is using the same

IP address as the IP KVM switch before connecting it to the network, to avoid a conflict.

Should an IP address conflict occur with another device on the network, power off the

conflicting device or assign it another IP address before continuing the installation.
NOTE: Not all IP addresses are valid for a given subnet. If you are required to change

your subnet (and therefore IP address) to configure the unit, be sure the IP address you

choose is within the allowable range for the 255.255.255.0 subnet.
Once your computer is configured to the same subnet as the IP KVM switch, you can

use the IP address 192.168.1.123 to access the Web configuration system.

This manual is related to the following products: