Reznor R6GN Option - Installation - High Static Blower Drive - Light Commercial - Manual (Page 20)

20
R6GP-090*-200C MSD kits:
920607 (208-230V, 3Ø, 60 Hz)
920606 (460V, 3Ø, 60 Hz)
Horizontal Flow Performance Chart* ‡ Indicates Factory Sheave Setting for Pre-confi gured Units
External
Unit Static
(in-Wg)
Operating @
230 or 460
Volts
Adjustable Motor Sheave Setting
Fully
Closed
1/2 Turn
Open
1 Turn
Open
1.5 Turns
Open
2.0 Turns
Open ‡
2.5 Turns
Open
3.0 Turns
Open
3.5 Turns
Open
4.0 Turns
Open
4.5 Turns
Open
5.0 Turns
Open
5.5 Turns
Open
6.0 Turns
Open
0.8
CFM 3310 2993
RPM 1019 979
kW 1.75 1.50
0.9
CFM 3492 3185 2878
RPM 1066 1028 990
kW 1.90 1.65 1.40
1.0
CFM 3549 3339 3020 2700
RPM 1102 1074 1039 1004
kW 2.00 1.80 1.55 1.30
1.1
CFM 3347 3107 2808 2508
RPM 1108 1080 1046 1012
kW 1.90 1.70 1.45 1.20
1.2
CFM 3423 3149 2875 2583
RPM 1140 1112 1084 1053
kW 2.00 1.75 1.50 1.30
1.3
CFM 3435 3223 2950
RPM 1172 1144 1118
kW 2.10 1.80 1.60
1.4
CFM 3502 3196 2889 2668
RPM 1207 1179 1150 1126
kW 2.20 1.95 1.70 1.40
1.5
CFM 3520 3281 2969 2657
RPM 1238 1212 1184 1155
kW 2.40 2.10 1.85 1.60
1.6
CFM 3317 3063 2776
RPM 1242 1216 1189
kW 2.25 2.00 1.75
* Requires horizontal conversion kit. Please refer to unit TSL for kit number.
Values include losses for: Unit Casing, 2” Disposable Filters, Dry Evaporator Coil & Installed Heat Exchanger
Values shown refl ect operation at 230V or 460V. For operation at 208V, deduct 0.025 from unit static.
3862
Indicates a recommended unit operational point 1159
3.03
3493
Indicates an allowable setting that is not recommended for unit operation †
† These operational points should be carefully examined by the installer for proper unit setup and heater operation if used.
1017
2.07
Indicates a setting that is not permitted for unit operation
Table 16. Blower Performance for R6GP-090*-200C Units
(7.5 Ton Horizontal Models Only)