Reznor R6GN Option - Installation - High Static Blower Drive - Light Commercial - Manual (Page 16)

16
R6GP-072*-100C MSD kits:
920609 (208-230V, 3Ø, 60 Hz)
920560 (460V, 3Ø, 60 Hz)
Horizontal Flow Performance Chart* ‡ Indicates Factory Sheave Setting for Pre-confi gured Units
External
Unit Static
(in-Wg)
Operating @
230 or 460
Volts
Adjustable Motor Sheave Setting
Fully
Closed
1/2 Turn
Open
1 Turn
Open
1.5 Turns
Open ‡
2.0 Turns
Open
2.5 Turns
Open
3.0 Turns
Open
3.5 Turns
Open
4.0 Turns
Open
4.5 Turns
Open
5.0 Turns
Open
5.5 Turns
Open
6.0 Turns
Open
0.8
CFM
RPM
kW
0.9
CFM 2618 2403 2188
RPM 975 948 920
kW 1.12 0.98 0.84
1.0
CFM 2577 2367 2073 1865
RPM 1006 980 952 924
kW 1.17 0.99 0.88 0.70
1.1
CFM 2562 2361 2085
RPM 1037 1006 983
kW 1.21 1.07 0.93
1.2
CFM 2575 2328 2085
RPM 1062 1041 1011
kW 1.31 1.10 0.95
1.3
CFM 2601 2356 2048
RPM 1094 1066 1045
kW 1.36 1.18 0.98
1.4
CFM 2580 2357 2126
RPM 1122 1099 1071
kW 1.46 1.25 1.12
1.5
CFM 2569 2323 2129
RPM 1149 1125 1104
kW 1.51 1.33 1.16
1.6
CFM 2307
RPM 1154
kW 1.37
* Requires horizontal conversion kit. Please refer to unit TSL for kit number.
Values include losses for: Unit Casing, 2” Disposable Filters, Dry Evaporator Coil & Installed Heat Exchanger
Values shown refl ect operation at 230V or 460V. For operation at 208V, deduct 0.025 from unit static.
3862
Indicates a recommended unit operational point 1159
3.03
3493
Indicates an allowable setting that is not recommended for unit operation †
† These operational points should be carefully examined by the installer for proper unit setup and heater operation if used.
1017
2.07
Indicates a setting that is not permitted for unit operation
Table 12. Blower Performance for R6GP-072* Units
(6 Ton Horizontal Models Only)