Reznor R6GN Option - Installation - High Static Blower Drive - Light Commercial - Manual (Page 18)

18
R6GP-072*-166C MSD kits:
920613 (208-230V, 3Ø, 60 Hz)
920618 (460V, 3Ø, 60 Hz)
Horizontal Flow Performance Chart* ‡ Indicates Factory Sheave Setting for Pre-confi gured Units
External
Unit Static
(in-Wg)
Operating @
230 or 460
Volts
Adjustable Motor Sheave Setting
Fully
Closed
1/2 Turn
Open
1 Turn
Open
1.5 Turns
Open ‡
2.0 Turns
Open
2.5 Turns
Open
3.0 Turns
Open
3.5 Turns
Open
4.0 Turns
Open
4.5 Turns
Open
5.0 Turns
Open
5.5 Turns
Open
6.0 Turns
Open
0.8
CFM
RPM
kW
0.9
CFM 2755 2510 2265
RPM 981 956 930
kW 1.18 1.04 0.90
1.0
CFM 2732 2511 2240 1968
RPM 1013 987 960 933
kW 1.28 1.09 0.95 0.81
1.1
CFM 2714 2470 2225
RPM 1042 1017 991
kW 1.31 1.14 0.98
1.2
CFM 2708 2456 2214
RPM 1073 1047 1021
kW 1.41 1.21 1.02
1.3
CFM 2722 2446 2170
RPM 1103 1077 1051
kW 1.44 1.26 1.08
1.4
CFM 2696 2454 2204
RPM 1131 1105 1082
kW 1.54 1.31 1.11
1.5
CFM 2706 2473 2351
RPM 1159 1137 1107
kW 1.54 1.36 1.23
1.6
CFM 2713 2426 2232
RPM 1187 1166 1143
kW 1.66 1.43 1.27
* Requires horizontal conversion kit. Please refer to unit TSL for kit number.
Values include losses for: Unit Casing, 2” Disposable Filters, Dry Evaporator Coil & Installed Heat Exchanger
Values shown refl ect operation at 230V or 460V. For operation at 208V, deduct 0.025 from unit static.
3862
Indicates a recommended unit operational point 1159
3.03
3493
Indicates an allowable setting that is not recommended for unit operation †
† These operational points should be carefully examined by the installer for proper unit setup and heater operation if used.
1017
2.07
Indicates a setting that is not permitted for unit operation
Table 14. Blower Performance for R6GP-072*-166C Units
(6 Ton Horizontal Models Only)