Juniper Systems TK6000 User Guide - Manual (Page 7)

Getting Started
Installing the Battery Packs
To get started, you first need to install the battery. The Field
PC is equipped to handle two battery packs at a time. Both
batteries are not needed for operation. Using two battery packs
extends the operating time of the unit.
1. Use the edge of a key or a flat point screwdriver to open the
two quarter turn latches that release the battery door from
the unit.
2. Remove the battery door.
Note: The hand strap is attached to the battery door and does not need
to be removed to open battery compartment.
3. Insert the battery pack(s) so battery contacts match up. The
bottom slot is the main battery while the upper slot is the
auxiliary battery. To use the upper slot, remove the plastic
plug that protects the connectors.
Plastic plug
Note: When using one battery pack, the pack can be placed in either
compartment. The unit feels more balanced if placed in the bottom slot.
cAUTiON: When not using a battery in the auxiliary slot, use
the plastic plug for the auxiliary contacts. Failure to do so may
cause corrosion on the auxiliary contacts.
!!
Ch 1 Getting Started
7