Juniper Systems TK6000 User Guide - Manual (Page 19)

Note: The device cannot be powered off while it is plugged into the
wall charger.
3. Tap Power Off. A warning dialog appears. Tap OK.
To power on your Field PC, hold down the Power button until
you see the screen light up.
Note: The Battery Settings screen will appear when you power on
your Field PC .
Suspending the Device
Suspending the Field PC is different from powering it off.
When the device is suspended it goes to sleep, and when it
is turned back on, the device resumes where it was prior to
syspending it. Some battery power is used.
We recommend suspending your device if you plan to turn it
off for less than two weeks and if it is attached to a wall charger
when it is not being used.
To suspend your device, press the Power button briefly and
release. To resume the device from suspend mode, press the
Power button again.
Resetting the Device
Follow the steps below to reset the Field PC:
1. Save your open files and close any running programs.
2. Press and hold the Power button until the Power Button
menu appears.
3. Choose Reset.
If your device locks up, you can reset the device by pressing the
Power button for 10 seconds or until the screen goes dark. After
a few seconds, the device turns on again.
Ch 3 Using the Hardware
1