Juniper Systems Allegro CE Manual - Manual (Page 268)

Page 8-30 Expansion Pods
The Allegro with an 802.11b expansion pod is shipped with the
following Cisco items:
• Cisco Aironet 350 802.11b PC card (installed in your Allegro)
• Rubber duck antenna with a 90-degree pivoting joint
• Read Me First – EAP Authentication Requires Matching 802.1x
Protocol Drafts
• Release Notes for Cisco Aironet Wireless LAN Adapters
• Cisco Aironet Wireless LAN Client Adapter Quick Start Guide
• Cisco Aironet Wireless LAN Client Adapter CD-ROM
▲ ▲ ▲ ▲ ▲ Getting Started
To start using 802.11b on your Allegro you will need to do the
following:
1. Attach the rubber duck antenna.
2. Locate, read, and follow the Cisco instructions for setting up an
access point for 802.11b, if you have a Cisco access point.
3. Locate, read, and follow the Cisco instructions for setting up
profiles on your Allegro for 802.11b.
4. Locate, read, and follow the Cisco instructions for connecting to
the WLAN.
▲ ▲ ▲ ▲ ▲ Antenna Attachment
The rubber duck antenna shipped with your 802.11b Allegro must
be used with the 802.11b expansion pod. No other antennas are
accepted or supported. To attach the antenna to the expansion pod,
complete the following steps:
1. Place the antenna on the mount at the top of the expansion pod.
2. Screw the antenna firmly into place.
3. Rotate the antenna so that the 90-degree joint is positioned so it
can pivot upward to a 90-degree angle.