Jaypro Sports MHWM-D-A - Manual (Page 25)

© 2005 Jaypro Sports Equipment JSL-Inst001 Rev G 10-24-2006 25 of 40
b. If unit is a single mat hoist system, pay out just enough cable to reach the load bar on the floor,
then assemble the dead end of the cable to the eyebolt on the load bar as shown below.
Figure 27: Cable Attached to Eyebolt via Shackle - Single Mat Hoist
c. Never allow cable wraps to build up on top of one another on the hoist drum. There should be
more than adequate drum length to provide for sufficient lifting of hoist load bar without
multiple wraps on drum.
10. MatLok™ Fall Arrester (Optional Equipment)
a. System may have been shipped with a MatLok™ fall arrester or safety strap assembly. See
figure below for a general beam mounted installation. See installation drawings that accompany
the MatLok™ for more information. MatLoks™ can be ordered directly from Jaypro.
Figure 28: MatLok Fall Arrester