Interlogix Simon XT Tabletop Installation Manual - Manual (Page 73)

Chapter 5:
Simon XT TableTop Control Panel Installation Manual 67
4. Press * and the panel voice identifies the alarm. If there is more than one
alarm in progress, the user must press * for the panel voice to identify them.
Note: You must terminate the call by pressing #. Otherwise, the panel may
not disconnect from the phone line for up to 2 minutes.
5. After all alarms have been identified, the panel announces Press # to exit.
6. Press # to terminate the call.
X10 operation
The following sections describe how to test X10 lamp, siren, appliance, and
universal module operation.
Manual lamp module control
Use the following methods to test manual lamp module control:
Control panel
Press the asterisk button (*) and the unit number of the lamp module using the
numeric buttons to test individual lamp modules 1 through 8. The panel responds
with Light # on/off. Press the asterisk button (*) twice to turn on all lamp modules.
Press the pound button (#) twice to turn off all lamp modules.
Keyfob
Press the Light button repeatedly to turn all lights on and off. The panel responds
with Lights on/off.
Remote handheld touchpad
Press the Lights on button and the unit number of the lamp module using the
numeric buttons to test individual lamp modules 1 through 8. The panel responds
with Light # on/off. Pressing the Lights on or Lights off button twice turns all the
lights on or off.
Simon XT TableTop touchpad
Press the Lights on button and the unit number of the lamp module using the
numeric buttons to test individual lamp modules 1 through 8. The panel responds
with Light # on/off. Pressing the Lights on or Lights off button twice turns all the
lights on or off.