Interlogix Simon XT Tabletop Installation Manual - Manual (Page 49)

Chapter 4:
Simon XT TableTop Control Panel Installation Manual 43
Sensors
These instructions explain how to add (learn) sensors, touchpads, and other
system devices into panel memory. The panel recognizes a sensor when you
press a sensor program button, press and release a tamper switch, press a
sensor test button, or put a sensor into alarm. Table 14 below describes the
programming method for each device.
Note: If you are installing a sensor on a gun case, jewelry box, or a similar case,
and the sensor is active in level one, you must subdisarm to avoid putting the
panel into alarm when the sensor and the magnet are separated.
Table 14: Device programming
Device To program
Door/window sensor Press the button on the top of the sensor (cover removed) or trip the
tamper.
Motion sensor Press the button on the back of the sensor (mounting plate removed) or
trip the tamper.
Smoke detector Trip the tamper, press the test button, remove the detector from its base,
or put the smoke detector in alarm.
Hardwired sensor Separate the sensor from its magnet.
CO alarm Plug in the module wait five to seven seconds press and hold the test
button for nine beeps
Freeze and water
sensor Trip the tamper or press and hold the button on the top of the sensor
(cover removed) until the control panel confirms programming. If you do
not hold the button down long enough, the system will report the sensor
as open.
Personal help button Press the help button until the light blinks.
Remote handheld
touchpad Press the emergency buttons.
Simon XT TableTop
touchpad Press the lights off button six times in rapid succession.
Keyfob Press the lock and unlock buttons at the same time.
ELM keyfob Do the following:
1. Press the unlock button twice and hold it the third time. The light
flashes three times.
2. Press the unlock button once and hold it the second time. The light
flashes twice.
3. Press and hold the unlock button. The light flashes once. Hold the
button until the flashing stops.