Interlogix Simon XT Tabletop Installation Manual - Manual (Page 71)

Chapter 5:
Simon XT TableTop Control Panel Installation Manual 65
System Function Phone command
Specific light off # – .
All lights on * – *
All lights off # – #
System status 0
Audio verification 5 + X (X = a command from Audio Verification
Set)
Terminate session 9
Central station communication
After performing sensor and communication tests, check that the system is
reporting alarms successfully to the central station. Table 31 below provides a list
of sensor/user report codes.
To test communication with the central station, do the following:
1. Call the central station and tell the operator that you will be testing the
system.
2. Arm the system.
3. Test each of the wireless panic buttons and trip at least one sensor of each
type (fire, intrusion, etc.) to verify that the appropriate alarms are working
correctly.
4. When you finish testing the system, call the central station to verify that the
alarms were received.
Table 31: Sensor/user report codes
Arm or disarm from Reports as user
Panel or remote touchpad 0
Keyfob 1 to 40 (sensor number)
Panel aux panic 41
Panel tamper 42
Panel police panic 43
Panel fire panic 44
Dealer access code 44
Installer access code 45
Master code 46