Interlogix Simon XT Tabletop Installation Manual - Manual (Page 43)

Chapter 4:
Simon XT TableTop Control Panel Installation Manual 37
2. The display shows Enter code. Enter your code with numeric keys. Press
Enter.
3. Press Enter.
4. The display now flashes the hours. Scroll up/down to set the hours. Press
Enter to accept.
5. The display now flashes the minutes. Scroll up/down to set the minutes.
Press Enter to accept.
6. The display now flashes the AM/PM. Scroll up/down to set the AM/PM. Press
Enter to accept.
7. The display now shows the current time, and stops flashing. Press Status
twice to exit.
Revision
To display the firmware revision of the system, do the following:
1. Scroll up/down to Revision.
2. Press Status to exit.
Contrast
To adjust the contrast of the display, do the following:
1. Scroll up/down to Contrast. Press Enter.
2. Scroll up/down to increase and decrease the contrast setting.
3. Press Status to save the setting and exit.
Note: Changes in contrast are more noticeable when not looking at the display
straight-on.
System programming
To enter system programming mode, do the following:
1. Press the scroll buttons until the panel displays System programming. Press
Enter.
2. The system prompts for an access code. Enter the access code from the
codes listed in Table 9.