Interlogix Simon XT Tabletop Installation Manual - Manual (Page 42)

Chapter 4:
36 Simon XT TableTop Control Panel Installation Manual
Phone 3 reports Vox receiver gain
Phone 4 reports Vox microphone gain
Timers Vox gain range
Latchkey time Manual microphone gain
Entry delay Light control
Exit delay Set entry lights
No activity timeout Sensor lights
Auto phone test Light schedules
Supervisory time Housecode
Alarm cancel window Lock interval
RF timeout System tests
Fail to open time Sensor test
Fail to close time Communication test
Siren timeout Initiate download call
Arming LEDs shutdown Revision
Unvacated premises Contrast
Smoke sensor supervision
Touchpad options
Keyfob no delay
Panel panic alarms
Remote touchpad arming
Set clock
If the panel loses both AC and battery power, then upon restoring power the
system time will reset to midnight and blink, indicating it has not been set
correctly. You can set the system time to display in either 12-hour or 24-hour
format.
Time of day format is HH:MMx, where:
HH = 01 to 12 (12-hour format) or 00-23 (24-hour format)
MM = 00 to 59
x = a or p (12-hour format) or none (24-hour format)
To reset the clock, do the following:
1. Scroll up/down until the display shows Set clock. Press Enter.