Interlogix Simon XT Tabletop Installation Manual - Manual (Page 28)

Chapter 3:
22 Simon XT TableTop Control Panel Installation Manual
Panel connections
The panel has three screw terminals, two telephone connections, and a 9 VAC
plug (Figure 3).
Figure 3: Simon XT TableTop Control Panel terminal connections
Hardwired device terminals
The screw terminals connect sirens, and/or hardwired detectors.
Program sensors and devices before you install them. Follow the instructions in
Sensors on page 35 to add the sensors to panel memory.
HW1 I/O, HW2 In, and HW1&2 DC Out terminals
The HW1 I/O terminal is dual purpose and can be used for either siren or
hardwired contact connections. The HW2 In terminal is an input only.
Interior sirens
From the factory, the HW1 I/O terminal input is set up for interior siren operation
(status and alarm sounds). HW1&2 DC Out provides the positive (+) voltage.