Interlogix NS3702-24P-4S Command Line Guide - Manual (Page 288)

-288-
tacacs-server
Configure TACACS+
deadtime
Time to stop using a TACACS+ server that doesn't respond
Time in minutes
Default:
0
Usage Guide:
To configure the Deadtime of TACACS+ Server
Example:
To enable the Deadtime (6) of TACACS+ Server
Switch# configure terminal
Switch (config)# tacacs-server deadtime 6
4.2.179 tacacs-server host
Command:
tacacs-server host [ port ] [ timeout ] [ key ]
tacacs-server
Configure TACACS+
host
Specify a TACACS+ server
Hostname or IP address
key
Server specific key (overrides default)
port
TCP port for TACACS+ server
TCP port number
timeout
Time to wait for this TACACS+ server to reply (overrides default)
Wait time in seconds
The shared key
Default:
None
Usage Guide:
To configure the Host of TACACS+ Server
Example:
To enable the Host (below table) of TACACS+ Server