3 requirements, User mode, Privileged mode – Interlogix NS3702-24P-4S Command Line Guide User Manual
Page 20: Global config mode, Interface config mode

-20-
The CLI provides the following modes:
User Mode
When the operator logs into the CLI, the User Mode is the initial mode. The User Mode contains a limited set of commands. The
command prompt shown at this level is:
Command Prompt: switch>
Privileged Mode
To have access to the full suite of comm ands, the operator must enter the Privileged Mode. T he Privileged Mod e requ ires
password authentication. From Privileged Mode, the operator can issue a ny Exec command to enter th e Global Configuration
mode. The command prompt shown at this level is:
Command Prompt: switch#
Global Config Mode
This mode permits the operat or to make modificati ons to the running configuration. General setup commands are gr ouped in
this mod e. F rom the Glob al Configuration mode, the op erator can enter the In terface Confi guration mode. T he c ommand
prompt at this level is:
Command Prompt: switch(Config)#
From the Global Config mode, the operator may enter the following configuration modes:
Interface Config Mode
Many features are enabled for a particular interface. The Interface commands enable or modify the operation of an interface. In
this mode, a physical port is set up for a specific logical connection operation. The command prompt at this level is:
Command Prompt: Switch(Interface
1.3 Requirements
Workstations
running Windows XP/Vista/7/8/, Windows 2003/2008, MAC OS X or l ater, Linux, UNIX, or oth er platforms
are compatible with TCP/IP protocols.
Workstations are installed with Ethernet NIC (Network Interface Card)
Serial Port
Connection (Terminal)
The above Workstations come with COM Port (DB9) or USB-to-RS-232 converter.
The above Workstations have been installed with terminal emulator, such as Hyper Terminal included in Windows
XP/2003.
Serial cable
-- one end is attached to the RS-232 serial port, while the other end to the console port of the Managed
Switch.
Ethernet Port
Connection
Network cables -- Use standard network (UTP) cables with RJ-45 connectors.
The above PC is installed with Web Browser and JAVA runtime environment plug-in.