Flintec FAD-30 - Manual (Page 36)

FAD-30 Technical Manual, Rev. 1.06 December 2012 Page 36 of 48
Load Cell Connection
See chapter 4.2.2
Power Supply Connection:
See chapter 4.2.1
7.3. Interfacing
FAD-30PB instruments have two interface connectors on the front of the instrument: Profibus and RS-232C.
The table below describes the data formats for interfacing the peripherals and their application.
Data Format Description Application Hardware
Profibus Profibus interfacing.
Refer to chapter 5.11 Interfacing with PLC Profibus-DP-V1
Table 7.2 – Data output interfacing
Attention: Please disable the interface you will not use to increase the performance of the instrument.
7.4. Setup and Calibration
FAD-30PB instruments are set up and calibrated by xFace. The A/D Converter settings are very important for a
good weighing performance. Please refer to chapter 5.3.
7.5. Profibus Setup
The Profibus setup is done by xFace software as described in this chapter. Select the Gateway tab after
connecting xFace to the instrument. You will see the Profibus parameters in this tab.
Profibus Setup
There is only one setup parameter for Profibus network.
Profibus Rack Address The address range is 1 (default setting) to 126
Profibus DP Data Structure
Please refer to chapter 5.11