EVCO c-pro kilo - Manual (Page 11)

C-PRO KILO HARDWARE MANUAL
Page 11
Connection with a remote expansion (or another CAN controller):
The connection between C-PRO KILO and the remote expansion (or other CAN controller) is made using a 2
way cable (better if weaved) plus possible ground.
The maximum length of the connection cables to the remote controllers or expansions depend on the CAN port
baud rate (see above section “User interface connections”).
Notes on the electrical connections:
-
do not use electric or pneumatic screw-wrenches on the terminal board
- if the device has been moved from a cold to a warm environment, condensation may have formed
inside; please wait approx. one hour prior to switching on
- ensure that the voltage, frequency and operational power of the device are compatible with the local
power supply
- disconnect the power prior to proceeding with any kind of maintenance operation
- do not use the device as a safety device
- for repairs and any information relating to the device, contact the Evco dealer network.
Caution
The indications regarding maximum connecting cable length infer that a series of precautions are complied
with:
To avoid immunity problems, it is good practice to observe the following points:
- Avoid locations with antennae
- Avoid cabling probe inputs and relay outputs together; more generally, avoid mixing low and high
voltage signals with one another
- Avoid wrapping cable around power components
To avoid any safety issues, it is good practice to observe the following points:
- Avoid premises with relative humidity >90%
- Avoid moisture
- Avoid corrosive environments
- Avoid explosive environments
Strategies
Finally, ensure that the operating conditions are within the operating limits indicated in the technical
characteristics.