EVCO EPK4LHX Hardware manual User Manual
Page 16
EVCO S.p.A.
c-pro 3 NODE kilo | Hardware manual ver. 1.0 | Code 114CP3NKE104
page 16 of 44
4.8
Example of electric connection
The following drawing shows and example of the electric connection of the devices.
4.9
Warnings for the electric connection
-
do not use electric or pneumatic screwdrivers on the device terminal board
-
if the device has been taken from a cold to hot place, humidity could condense inside; wait about 1 hour before powering it
-
make sure that the power supply voltage, the frequency and the operational electric power of the device, correspond with
those of the local power supply; see chapter 8 “TECHNICAL DATA”
-
disconnect the device power supply before proceeding with any type of maintenance
-
connect the device to a RS-485 network using a twisted pair
-
connect the device to a CAN network using a twisted pair
-
position the power cables as far away as possible from the signal cables
-
do not use the device as a safety device
-
for repairs and information regarding the device, contact the EVCO sales network.