EVCO EPK4BHQ1AH Hardware manual - Manual (Page 30)

EVCO S.p.A. c-pro 3 NODE kilo+ | Hardware manual ver. 1.0 | Code 114CP3NKPE104
page 30 of 55
ELECTRIC CONNECTION ”.
3. Connect the controllers power supply
4. Keep the UP and DOWN keys pressed for 2 s: the following menu shall appear on the display,
Info
English
Parameters
Networks
Backup/Restore
Diagnostic
Debug
5. Press and release the UP or DOWN key to select "Networks".
6. Press and release the ENTER key.
7. Press and release the ENTER key again to set the password
8. Press and release the DOWN key repeatedly to set "-19".
9. Press and release the ENTER key again.
10. Press and release the UP or DOWN key to select "CAN Bus".
11. Press and release the ENTER key again.
12. Set the "NetworkNode" parameter using the UP or DOWN keys to select the parameter and the ENTER key to change and
confirm the relevant value.
The default setting of the CAN node is 1 (operate on the controller to set the "NetworkNode" parameter to [ 1 ] 1).
13. Press and release the UP or DOWN key to select ">".
14. Press and release the ENTER key again: the "Main menu" of the blind controller shall be shown on the display.
15. Proceed as shown in paragraph 6.1 “Configuration of abuilt-in LCD programmable controller”.
6.3 I/O expansion configuration
The following procedures show an example of how to configure an I/O expansion through a built-in programmable controller (in the
example, c-pro 3 NODE kilo) and its user interface.
Proceed as follows:
1. Disconnect the power supply of the controller and the expansion
2. Connect the blind controller through the CAN CANBUS port; see chapter 4 “