EVCO EPK4BHQ1AH Hardware manual - Manual (Page 12)

EVCO S.p.A. c-pro 3 NODE kilo+ | Hardware manual ver. 1.0 | Code 114CP3NKPE104
page 12 of 55
To remove the devices, first remove any screw-in removable terminal boards mounted in the lower part, then trigger the DIN track clip
with a screwdriver as show in the following picture:
3 4
To install the devices again, first press the clip of the DIN track.
3.3 Installation warnings
- make sure that the device work conditions (temperature of use, humidity, etc.) lie within the limits indicated; see chapter 8
“