Operating procedures, 1 weighed commodity operation, Weighed commodity operation -1 – Toshiba TEC EM1-31059 User Manual
Page 78
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
9. OPERATING PROCEDURES
EM 1-31059
9.1 WEIGHED COMMODITY OPERATION
9. OPERATING PROCEDURES
NOTES BEFORE STARTING OPERATION
(1) Be sure to plug the power plug into an AC outlet.
(2) When the power switch is turned on, the scale goes through the test scanning sequence, such as
0000,0000,00000, then 1111,1111,11111.....................and zeros appear on the displays.
(3) While the scale is in the test sequence, do not put anything on the platter.
(4) Do not move the unit while it is in operation. Should it become necessary to move it at any time,
turn the power switch to the OFF position and be sure to readjust the level indicator after
relocating the scale.
(5) Should a power failure occur during operation, remove the commodity from the platter and insert
the power plug into an AC outlet again when power is restored.
(6) If the scale is used with an unrated power source, inaccurate scaling or other errors may occur.
(7) If the zero point has shifted during scaling, and no tare is displayed, adjust the zero point by
depressing the ZERO key.
9.1 WEIGHED COMMODITY OPERATION
Control lock:
REG, M.DOWN, or REWRAP
Mode SW (2): WEIGH
In the event that PLU #100 and an unit price of $10.00 are set in the speed key #12.
(Sample label)
NOTE: Depressing a speed key to which no PLU data has been assigned will result in an error. In this
case, depress the key, then depress a speed key to which PLU data has been assigned.
9-1