Error message table, Error message table 2 - 1 – Toshiba TEC EM1-31059 User Manual
Page 102
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
12. ERROR MESSAGE TABLE
EMI-31059
Programming Mode
12. ERROR MESSAGE TABLE
if an error message has appeared on the message display with the buzzer
• Programming Mode
Control lock: PROG./CMT.
Take the following action
sounding.
Message
Cause
Solution
DATA ENTRY ERROR
Error in key input
Depress the CLEAR kev, and re-
input the correct data.
MEMORY FULL
No memory space to set PLU.
Depress the CLEAR
I
kev. and set
after deleting unwanted PLUs.
DUPLICATE PLU
The PLU# being changed is already
registered.
Depress the CLEAR | kev. and
check the PLU data.
PLU NOT FOUND
The PLU# being called out is not
registered.
Deoress the ICLEARI kev. and
check the PLU data.
CHARACT. OVERRUN
Attempt is made to set more than
max. allowed number of characters.
Depress the CLEAR kev, and re-
input the right data.
PRT FAILURE
Printer trouble
1. Check that the label and print
head are set correctly.
2. If the label home position is
misaligned, press the FEED
key.
RESTORE THE PLUS
In the initial setting, RAM capacity
which exceeds the capacity of the
installed FIAM is selected.
1. Deoress the
1
CLEAR
I
kev. and
re-set the initial setting.
2. Call for service, and change the
FIAM capacity.
LABEL SENSE ERR.
The label interrupts the sensors.
Depress the
I
CLEAR
I
kev, then the
FEED key and remove the label.
1 2 - 1