Toshiba TEC EM1-31059 - Manual (Page 104)

12. ERROR MESSAGE TABLE
EMI-31059
Label Issue Mode
• Label Issue Mode
Control lock: REG ./MARK DOWN/REWRAP
Message Cause Solution
DATA ENTRY ERROR Error in key input Depress the C key, and re-input.
PLU NOT FOUND The PLU# being called out is not
registered. Depress the C key, and check the
PLU data.
TOTALS OVERFLOW GRAND TOTAL or PLU TOTAL
memory has overflowed at the time
of issuing a label. Depress the C key, and turn the
control lock at “Z” position. Then
sum up the overflowing memory.
PLU DATA ERROR Error in PLU data. Depress the key, and check the
PLU data.
PRT FAILURE Printer trouble 1. Check that the label and print
head are set correctly.
2. If the label home position is
misalianed, press the I FEED
key.
CASSETTE ERROR Label cassette is not set correctly. Set the cassette correctly.
Cassette switch is not set correctly. Set the cassette switch correctly.
Setting of control lock position and
cassette switch is not correct.
When control lock position is set to
other than “X” or “Z”, set the
cassette
switch to “LABEL
POSITION”.
LABEL SENSE ERR. The label interrupts the sensors. Depress the key, then the
FEED I key and remove the label.
• Read and Reset Mode
Control lock: X (read)/Z (reset)
Message Cause Solution
PLU NOT FOUND Corresponding PLU# or UPC# is
not registered. Depress the key, and enter the
correct PLU#.
NO REGISTED There is no combination report
setting data. Depress the key, and check the
combination report tables.
PRT FAILURE Printer trouble. Same as in the label issue mode.
CASSETTE ERROR Label cassette is not set correctly. Set the cassette correctly.
LABEL SENSE ERR. The label interrupts the sensors. Depress the key, then the
FEED I key and remove the label.
1 2 - 3