Battery pack 3-1. nicd bahery pack (pb-10), 2. recharging – Kenwood TH-26A User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3. BATTERY PACK
3-1. NiCd BAHERY PACK (PB-10)
This battery pack has not been charged at the factory in
order
to
provide
you
m\h
the
greatest
number
of
charge / discharge cycles. You must charge the battery
before
use.
The
battery
pack
will
require
several
charge / discharge cycles before you can expect to see
the maximum operating period between charges. If the
battery
will
be
stored
for greater
than
2
months it
should be recharged before use.
^
Adapter
3-2. RECHARGING
1.
Slide the adapter onto the
NiCd battery pack.
2.
Plug
the
supplied
charger
into an AC outlet.
3.
Do not allow the battery to
charge
for
greater
than
15
hours.
The
useful
life
and
battery
performance
will
be
reduced
if
you
exceed
the
recom
mended charge period.
BC-9
Kit
to AC outlet
Note
Recharging
should
be
performed
within
an
ambient
temperature
range
of
between
5°C
~
40°C
(41°F
~
104T).
Recharging the battery outside of this range may not
allow the battery to reach full charge.
3-3. MANGANESE or ALKALINE
(Optional Battery Case BT-6)
BAHERIES
Install 6
X
R6 (AA) manganese
or alkaline batteries in the bat
tery holder. Pay close attention
the
battery
polarities
marked
in
the
holder.
We
recommend
the
use
of
high
performance
manganese
batteries
for
the
greatest operating time.
Note
Do
not
install
NiCd
batteries
and
attempt
to
charge
them
with
the
supplied
charger.
There is no battery protection
circuit in the battery holder.
Press down on the hook in the
middle of the battery case top
to open.
Hook