Operation 4-1. operating controls – Kenwood TH-26A User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4. OPERATION
4-1. OPERATING CONTROLS
®Antenna connector
Connect the antenna that is supplied to this connector.
Twist to lock.
^Volume control / Power switch
The
volume
control
and
power
switch
are
combined.
Rotating the
control clockwise will
turn ON the
transceiver.
Advancing
the
control
further
clockwise
will increase the volume.
(DSQL control
This
control
is
used
to
select
the
desired
Squelch
threshold level.
®MHz key
This key is used to select the tuning rate of the Tuning
control.
When
the
MHz
indicator
is
lit,
the
Tuning
control will cause the transceiver to increase or decrease
in 1 MHz steps.
Press and hold the key for longer than 1 second to
initiate MHz scan. Pressing the key after scan has been
initiated will cause scan to stop.
Pressing the key within 10 seconds of pressing the F key
will allow you to change the frequency step.
Turn the power on while pressing this key to initiate the
Automatic Memory
Initialization. Automatic storage
will then
begin from the
frequency that appeared in
the
display
before
the
power
was
turned
off.
See
section 4-4-8 for
additional
information
on this
function.
(DVFO key
This
key
is
used
to
return
to
VFO
operation
after
operating
in
the
memory
channel
or
CALL
channel
mode.
The
Tuning
control
will
increase
or
decrease
frequency in accordance with the VFO indicator.
Press and hold the key for longer than 1 second to
initiate VFO scan. Pressing the key after scan has been
initiated will cause scan to stop.
Pressing the key within 10 seconds of pressing the F key
will copy the memory channel or call channel data to
the VFO. This allows you to change parameters or that
channel
without
actually
changing
the
data
that
has
been stored in memory.
12