B - (i, Tone/ctcss, V/m/c scan – Kenwood TH-26A User Manual
Page 35: 7. channel display mode
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4-7. CHANNEL DISPLAY MODE
Channels can be shown on the display.
(Ex.)
POWER OFF
POWER ON
MONI
A
.
B - (I
1.
Enter the desired operating
frequency
into
memory,
(o-
4-4-4.
Memory
Entry,
4-4-8.
Automatic
Memory
Initial
ization)
2.
Turn
off
the
transceiver
POWER switch.
3.
If you press and hold the
MONI switch while you turn
on the POWER switch.
To
return
to
the
frequency
mode,
repeat
the
same
operation (steps 2 and 3 above).
Note
In
the
channel
display
mode
only
the
following
functions are valid:
• MONI, PTT, LAMP svyitch, F key
• Functions shaded
I H
in the table below.
MHz
VFO
MR
T.ALT
CALL
REV
SHIFT
TONE/CTCSS
I
Key I
(iSec)
MHz SCAN
VFO SCAN
M.SCAN
CALL SCAN
0
Key
STEP
M. SHIFT
M. IN
BEEP
CALL IN
SHIFT
DTSS
TONE SEL
\T\
(ISec)
Key
MHz SCAN
V/M SCAN
LOCK OUT
TO/CO
V/M/C SCAN
DELAY
CODE SEL
Key 1 +
Power On
AUTO MEMO
VFO RESET
M.CLR
SAVE
A. P.O
UPPER SET
LOWER SET
MIC SW
35