beautypg.com

3. dtp-1 dtmf key pad installation – Kenwood TH-26A User Manual

Page 46

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

7-3. DTP-1 DTMF

KEY PAD INSTALLATION

Note
Be

sure

to

turn

the

POWER

switch

OFF

before

removing

the battery

case.

1.

Detach the battery case and remove the two screws

on

the

front

panel

which

are

used

to

hold

the

terminal plate on the bottom of the unit. (Fig.1)

2.

Remove the three screws that hold the front panel.

(Fig.1)

3. A flat

cable is attached

to the inside

of the front

panel.

Detach the

front panel

paying attention

to

the wiring. (Fig.2)

4.

Remove

the

three

screws

and

remove

the

panel.

(Fig.2)

5.

Remove

the

backing

paper

from

the

double-sided

adhesive tape attached to the DTP-1. (Fig.3)

6.

Thread

the

flat

cable

of

the

DTP-1

through

and

tighten the three screws. (Fig.4)

7. Attach the flat cable to the connector. (Fig.5)
8. Attach the front panel being careful not to pinch the

flat cable.

9. Tighten the three screws on the front panel.
10. Tighten the two screws on the bottom of the unit.

Fig. 5

46

This manual is related to the following products: