Kenwood TH-26A User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Channel No.
1~3
4~10
CALL
11—20
DTSS status
O
X
X
DTSS code
O
X
X
Split memory
X
X
O
^1: Channels 16 ~
20 are used
to store
DT MF data and
cannot be used as normal memory channels when
the DTMF memory function is on. If you are not
using the DTMF memory function channels 16 ~ 20
can be used as normal memory channels.
^2: When used as split memory.
When used as simplex memory.
4-4-4. Memory Entry
• Simple / Normal transmitter offsets
1.
Press the VFO key to select
the VFO mode.
2.
Select the desired operating
frequency,
offset
direction,
tone
frequency,
CTCSS
status
etc.
(For
example
146.790
MHz)
3.
Press the F key momentarily.
The F indicator will turn on
in the display, and a memory
channel
number
will
appear.
(Channel 8 for example)
24
X
o
4.
Select
the
desired
memory
channel
number
by
rotating
the
Tuning
control.
When
nothing
is
stored
in
a
memory
channel,
the
channel number flashes.
5.
Press the MR key within 10
seconds
of
selecting
the
memory
channel
number.
A
beep will sound and the F in
dicator
and
memory
channel
number
will
turn
off.
This
signal that the data has been
properly stored in memory.
• Odd Split Memory Channels
Press the VFO key to select
the VFO mode.
Select
the
desired
receiver
frequency,
tone
information
etc.
(For
example
145.600
MHz)
Press the F key momentarily.
The F indicator will turn on
in the display, and a memory
channel number will appear.
Select
any
memory
channel
from 11 thru 20 using the
Tuning
controls.
When
noth
ing is stored in a memory
o
A
flashing