Kenwood TH-26A - Manual (Page 30)

1. Adjust the SQL control to the threshold point.
2. Press the MHz key for longer than 1 second. The MHz
indicator will begin flashing as a visual reminder the
transceiver is scanning.
3. Scanning will start in an upwards direction over a 1
MHz range. You can change the direction of scan by
turning the Tuning control.
4. Scan will stop whenever a signal is received that will
open the squelch of the radio.
5. Press the PTT switch or any front panel key to stop
scan.
4-5-6. Memory Channel Scan
1. Adjust the SQL control to the threshold point.
2. Press the MR key for longer than 1 second. The MHz
indicator will begin flashing as a visual reminder the
transceiver is scanning.
4-5-5. MHz Scan
Note
Only those
memory channels that have data
entered, and
scanned.
that have not been locked out will be
3. Scan will begin in an upwards direction. You can
change the direction of scan by turning the Tuning
control.
4. Scan will stop whenever a signal is received that will
open the squelch of the radio.
5. Press the PTT switch or any front panel key to stop
scan.
4-5-7. VFO / Memory Channel Scan
1. Adjust the SQL control to the threshold point.
2. Pressing the F key for longer than 1 second and then
pressing the VFO key will initiate VFO / Memory scan.
3. Alternate scanning of the VFO frequency shown on
the display and the memory channel that was last
used.
4. Scan will stop whenever a signal is received that will
open the squelch of the radio.
5. Press the PTT switch or any front panel key to stop
scan.
4-5-8. CALL Scan
CALL / VFO Scan
Press the CALL key for longer than 1 second in the VFO
mode to start alternate scanning of the VFO frequency
shown on the display and the call channel.
CALL / Memory Channel Scan
Press the CALL key for longer than 1 second in the
memory
channel mode to start alternate scanning of
the call channel and the memory channel that was last
used.
30