Kenwood TH-26A - Manual (Page 26)

like the old crystal controlled radios, i.e. the data is
fixed and cannot be changed by mistake.
1.
Press the MR key to select the memory mode. The
memory channel indicator will turn on in the display.
2. Rotate the Tuning control to select the desired mem­
ory channel.
4-4-6. Memory Shift
Using this function you can copy the contents of a mem­
ory channel or call channel to the VFO without chang­
ing the data in memory. This will allow you to begin
tuning at the point specified by the memory channel
data.
1. Select the desired Memory
Channel. (For example Ch. 5)
2. Press the F key.
3. Within 10 seconds press the
VFO key to copy the data.
^luC C n/7 , ,
4-4-7. Clearing a Memory Channel [ f ]
If you want to clear the contents of an individual mem­
ory channel use the following procedure.
1. Press the MR key and select
the memory channel you
wish to clear. (For example
Ch.11)
2. Turn off the POWER switch.
Now press and hold the MR
26
key while you turn on the
POWER switch.
3. The selected memory chan­
nel number will disappear
and the next active memory
channel will appear. (For ex­
ample Ch. 1)
luC nn/7
nJ.Qu^ 11
4-4-8. Automatic Memory Initialization
This transceiver can automatically store data in memory
channels 1 thru 6 in the following steps.
This
automatic storage will begin from the frequency
that appeared in the display before the transceiver was
urned OFF.__________________________________________________
Caution
This procedure will erase all of the current data in
memory channels 1 thru 6.
. Select the desired starting
frequency using the Tuning
control.
2. Turn off the POWER switch.
3.
If you press and hold the
MHz key while you turn on
the POWER switch. Memory
channel 1 indicator will turn
on.
4. Rotate the Tuning control to
confirm data entry in the re­
maining channels (2 thru 6).
Ch.‘6 145.‘l25
loC
nnn